Check Power

• Check mains socket is active.
• Check fans are active when plugged directly into mains socket.

If fans and mains socket are functioning normally

• Set up controller as per User Instructions.

If there is still no power to controller

• Disconnect from mains and check/replace fuse in mains plug of controller, and if applicable, check/replace external fuse located on the outside of controller.

If there is still no power to controller

• Start RMA.

Check Fan Speed

• Set Minimum Fan Speed to 1 and Maximum Fan Speed to 5.
• Turn Temperature Dial to 10 degrees.

After a short time, fans should start to step up to Maximum Fan Speed.

• Turn Temperature Dial to 45 degrees

After a short time, fans should start to step down to Minimum Fan Speed.
If this does not happen

• Start RMA

Check Night-Pulse™

• Check feature is activated as per User Instructions.

Every hour or so throughout the dark cycle you should hear fans increase in speed for a short time, then the speed should decrease back to Minimum Fan Speed.

• Check feature is deactivated as per User Instructions.

Fans should remain at Minimum Fan Speed during dark cycle.
If this does not happen

• Start RMA

---